Kenmore 78079 Mode D'emploi page 15

Installation
Figure 22. Installing Outer Case in Window
1. Indoor sash
2. Top rail
3. Window sill gasket
4. Bottom rail
4. See Figure 23. Secure case to window sill by
screwing two 7 / " countersunk screws (Item B) into
8
sill through holes located in front support rail.
1
NOTE: Drill / " pilot holes in window sill to make screws
8
easier to drive.
Figure 23. Securing Outer Case to Window Sill
5. See Figure 24. Screw one 4" adjusting foot into
each outside support (Item D) as far as it will go.
(Adjustments can be made more easily after unit is
in place.) Do not attempt to straighten outside
supports or structural integrity of support may be
compromised.
Figure 24. Attaching Adjusting Foot to Outside Support
1. Outside support
2. Adjusting foot
1
2
6. Install outside supports underneath case using one
7. See Figure 25. Insert tabs on angled support arms
3
4
Figure 25. Attaching Outside Supports to Outer Case
1. Outer case
2. Insert back support arm tab in large hole
3. Support bracket
4. Attach front support arm with screw through small
15
½" screw (Item E) for each support. Mount vertical
arms (tab with hole) as close as possible to sill.
When properly positioned, adjusting foot faces
house.
into nearest large holes along bottom of outer case,
one side at a time. Align hole in vertical support arm
tabs with small holes in bottom of case and drive ½"
screws (Item E) into front tabs.
hole
1
4
1
2
2
3