Maintenance Procedures; Cleaning Air Discharge Louvers, Return Air Grille, And Electronic Control - Kenmore 78079 Mode D'emploi

Care and Maintenance

Maintenance Procedures

!
WARNING
To avoid death or personal injury due to electrical
shock, turn off fan control and unplug power cord
before cleaning or performing maintenance on this
device.
Air Filter Removal and Cleaning
NOTE: Never operate air conditioner with filter
removed.
Air filter can be removed in two ways:
· See Figure 39. Grasp filter handle and pull to the left.
When filter clears return air grille, pull out and away
from air conditioner.
Figure 39. Removing Air Filter, Method One
1. Air filter
1
· See Figure 40. Slide return air grille left until insert
guides are free of guide rails, then pull insert out and
away from front frame. Slide filter left until free of
retaining clips.
Figure 40. Air Filter Removal, Method Two
1. Return air grille
2. Air filter
2
Clean air filter by vacuuming. If filter is especially dirty,
clean with mild solution of warm soapy water. Rinse filter
of all soap residue and dry completely before
reinstalling.
Air Purification Filter
Optional, disposable air purification filter can be mounted
behind permanent filter to reduce smoke, odor, pollen,
and dust from area being cooled. After approximately 3
months of use, charcoal-impregnated air purification filter
should be discarded. New air purification filters are
available from Sears. Order part number:
· 20056001 (7000 and 9000 Btu air conditioners)
· 20064601 (12000 Btu air conditioners)
· 20075401 (18000 Btu air conditioners)
Optional Air Purification Filter Installation and
Removal
1. Remove permanent air filter from air conditioner.
2. See Figure 41. Insert 3 tabs on right side of air
3. Carefully bow center of air purification filter and
4. Relax bow. Air purification filter should rest against
5. Reinstall permanent air filter in air conditioner.
NOTE: Remove air purification filter by reversing
1. Air purification filter
2. Permanent air filter
Cleaning Air Discharge Louvers, Return Air
Grille, and Electronic Control
Clean air discharge louvers, return air grille, and
electronic control with sponge or cloth dampened with
mild soap or detergent and water. After cleaning, wipe
off soap residue with clean damp cloth and dry. Do not
use cleaners with abrasives or polishing compounds;
they may damage air conditioner surfaces.
1
24
purification filter into 3 matching slots on back of
permanent air filter frame.
insert 2 tabs on left side into matching slots on
permanent filter frame.
rear of permanent air filter.
installation procedure.
Figure 41. Air Purification Filter Installation and
Removal
2
1