Working Instructions And Calibration - Metrix MX 230B Notice De Fonctionnement

MX 230B
3 - WORKING INSTRUCTIONS - CALIBRATION 3 - WORKING INSTRUCTIONS - CALIBRATION 3 - WORKING INSTRUCTIONS - CALIBRATION
3 - WORKING INSTRUCTIONS - CALIBRATION 3 - WORKING INSTRUCTIONS - CALIBRATION
3.1 BATTERIES 3.1 BATTERIES 3.1 BATTERIES 3.1 BATTERIES 3.1 BATTERIES
Slide the lid at the back of the meter to open batteries and fuses
compartment:
0 - Pull the stand up.
1 - Press the legs of the stand towards the center.
2- Undo the safety screw.
3 - 4 -Slide towards the arrow as shown, the stand and the back
together, so as to uncover the batteries compartment.
5 - Galvanometer zero adjustment of pointer.
Place the 9 V PP3 and 1.5 V R6 batteries as indicated.
Remove test leads before opening the batteries compartment.
W A R N I N G W A R N I N G
W A R N I N G W A R N I N G : Disconnect the leads before opening the fuses and battery case. W A R N I N G
3.2 FUSES 3.2 FUSES 3.2 FUSES
3.2 FUSES 3.2 FUSES
When replacing fuse the right type.
Warning Warning Warning : Wrong fuse replacement will endanger meter safety. Warning Warning
2
5
3
4
23