Working Instructions And Calibration - Metrix MX 430B Notice De Fonctionnement

3 - WORKING INSTRUCTIONS - CALIBRATION 3 - WORKING INSTRUCTIONS - CALIBRATION 3 - WORKING INSTRUCTIONS - CALIBRATION
3 - WORKING INSTRUCTIONS - CALIBRATION 3 - WORKING INSTRUCTIONS - CALIBRATION
3.1 BATTERIES 3.1 BATTERIES 3.1 BATTERIES 3.1 BATTERIES 3.1 BATTERIES
Place the 9 V PP3 and 1.5 V R6 batteries as indicated.
Remove test leads before opening the batteries compartment.
Warning : Disconnect the leads before opening the fuses and battery case. Warning Warning
Warning Warning
3.2 FUSES 3.2 FUSES 3.2 FUSES
3.2 FUSES 3.2 FUSES
When replacing fuse, use the right type.
Warning Warning
Warning : Wrong fuse replacement will endanger meter safety. Warning Warning
26
2
5
Slide the lid at the back of the meter to open
batteries and fuses compartment:
0 - Pull the stand up.
1 - Press the legs of the stand towards the
center.
2 - Undo the screw.
3 - 4 - Slide towards the arrow as shown,
the stand and the back together, so as to
uncover the batteries compartment.
5 - Galvanometer zero adjustment pointer
3
4
MX 430B