Rating Label; Regulatory / Code Requirements; Location And Installation / Ventilation - hestan KRT304-NG Mode D'emploi

Table de cuisson, table de cuisson a 4 brûleurs et 1 brûleur intelligent
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

RATING LABEL

The rating label contains important information about your
Hestan appliance such as the model and serial number,
gas type and manifold pressure, electrical rating, the BTU
rating for each burner type, and the minimum installation
clearances.
The rating label is located underneath the unit.
If service is necessary, contact Hestan Customer Care with
the model and serial number information shown on the label.

REGULATORY / CODE REQUIREMENTS

Installation of this cooking appliance must be made in accordance with local codes. In the absence
of local codes, this unit should be installed in accordance with the National Fuel Gas Code ANSI
Z223.1/NFPA 54 , Natural Gas and Propane Installation code CSA B149.1 , or Propane Storage and
Handling Code B149.2 .
All Electrical Components must be electrically grounded in accordance with local codes or in the
absence of local codes with the National Electrical Code ANSI/NFPA 70 , or Canadian Electrical code
CSA C22.1 .
STATE OF MASSACHUSETTS
Massachusetts requires all gas be installed using a plumber or gas fitter carrying the appropriate
Massachusetts license. All permanently installed natural gas or propane installations require a
T handle type manual gas valve be installed in the gas supply line to this appliance. Flexible gas
connector must not be longer than 36" [91.4 cm].
CALIFORNIA PROPOSITION 65 - WARNING
WARNING
WARNING This product can expose you to chemicals including carbon monoxide, which is
known to the State of California to cause birth defects or other reproductive harm.
For more information, go to www.P65Warnings.ca.gov.

LOCATION AND INSTALLATION / VENTILATION

UNPACKING AND PLACEMENT
UNPACKING AND PLACEMENT
Remove the outer carton and packing materials. Do not remove the plastic film covering the
stainless-steel surfaces. This film protects the finish from scratches until the appliance is installed in
its final position.
The unit is somewhat heavy and should be handled with care. Use proper safety equipment, such as
gloves, and at least 2 persons to move the appliance into position to avoid injury and to avoid damage
to the floor or the appliance itself.
RATING
LABEL
©2021 Hestan Commercial Corporation
EN
3

Publicité

Chapitres

Table des Matières
loading

Table des Matières