Publicité
Les langues disponibles
Les langues disponibles
• Insert the tools are far as possible when clamping. En-
sure that the shaft of the tool does not stand out more
than 30 mm. Excessively protruding shafts can bend
easily and contribute to poor concentricity.
• Do not in any case use bits and cutters with an arbour
length of more than 55 mm!
• When using collets, always make sure that the collet
chuck and the utilised tool have the same shaft diam-
eter! The arbour of the tool must be seated firmly and
securely in the collet!
• Do not work with damaged, bent or worn bits and cut-
ters! Make sure the tools are in perfect condition.
Damaged or worn tools can break and cause injuries!
• When storing the bits and cutters, make sure they are
reliably protected from damage!
• A correct and consistent speed achieves a high grind-
ing performance, not excessive contact pressure!
• By tendency: Bits and cutters with smaller diameters
require higher speeds than those with a larger diam-
eter.
• Attention: You absolutely must observe the permissible
maximum speed of the bits and cutters! The tool can
break when the maximum permissible speed is ex-
ceeded. Flying parts can cause damage and severe in-
juries!
1. Slightly turn drill chuck 2 (Fig. 2) and simultaneously
press lock button (1) until the latter engages.
2. Open chuck and change bit.
Operating instructions
We recommend PROXXON collet chucks for optimal true
running.
Using the machine
Attention:
Secure the work piece during work! In addition to en-
abling more pleasant and efficient working, it also re-
duces the risk of the workpiece flying about!
Please note: A work piece flying about is a risk for in-
juries! Use a vice or suitable clamping fixture to hold the
work piece!
It is imperative to avoid electric tool recoil!
1. To activate, operate switch 4 (Fig. 1) and set the right
speed for the work on rotational speed adjusting knob
1. Applicable in principle, tools with smaller diameters
must be operated at higher speeds, and tools with
greater diameters at lower speeds in order to achieve
optimal results.
2. When cutting or engraving, hold the machine as if it
were a pen (Fig. 3), being careful not to occlude the
vent slits.
3. For roughing down, grip the machine as if it were a
hammer (Fig. 4).
Maintenance, cleaning and care
Attention:
Disconnect the mains plug prior to every adjustment,
maintenance measure or repair!
Every device is dirtied by dust when working with wood.
Cleaning is therefore essential. To ensure a long service
life, however, the machine should be cleaned with a soft
cloth or brush after each use.
Mild soap or other suitable cleaning agent may be used
in this context. Solvents or cleaning agents containing al-
cohol (e.g. petrol, cleaning alcohols, etc.) should be
avoided, since these can attack plastic casings.
The apertures required for cooling the motor must always
be kept free of dust and dirt.
Accessories
For more detailed information on accessories, please re-
quest our device catalogue from the address specified
on the last page in the warranty information.
Please note in general:
Proxxon bits and cutters have been designed to work with
our machines, which makes them optimal for their use.
We will not assume any liability whatsoever for the safe
and proper function of our devices when using third-party
bits and cutters!
Note:
- 15 -
Publicité
