Table des Matières
Publicité
Chassis variant
Bus ignore mode
- Chassis variant setup. In BeoVision Avant 32 DVD the line "Internal VCR" must
always be set to No.
Remember to check the line if the EEPROM 6IC6 has been replaced.
If an error occurs in the I²C bus system which makes the TV go into stand-by every
time it is attempted to be switched on, it is possible to switch on the TV in such a
way that the error is ignored:
- The TV must be on stand-by for at least 5 seconds.
- Short-circuit the service socket, P84 on AV Switch PCB14, coordinate 5L, for a
minimum of 0.5 second. See
- Remove the jumper.
- Press TV. The TV will now start up in the bus ignore mode if that is possible.
Repair tips, English
5.
5.17
Publicité
Table des Matières
