Dismantling - Bang & Olufsen BeoVision Avant 32 DVD MKI Mode D'emploi

DISMANTLING

Contrast screen, removal
Contrast screen, mounting
Mains Distribution, PCB60 (with mains voltage fuse)
Cloth front
Speaker cabinets
Motorized stand
STATIC ELECTRICITY
MAY DESTROY THE
PRODUCT
Illustrations are placed on page 6.21 – 6.22.
Remove the screws below the picture tube. See
upwards just below the Bang & Olufsen logo, and at the same time use the other
hand to carefully pull outwards at the top. Carefully remove the contrast screen.
Place the contrast screen in the metal brackets in the bottom corners of the front
frame. See 11. Grib the side edges of the screen with both hands and push
inwards.
Please note that it must be easy to push it into place. If not the contrast screen
may not be properly mounted in the metal brackets. The contrast screen might
shatter if being forced into place.
Push the contrast screen into place at the top, and gently push it down. Mount
the screws below the picture tube. See
For cleaning use a mild window cleaning fl uid. Make sure no streaks or traces are
left on the screen or picture tube. Make sure that no moisture is left between the
contrast screen and the front frame.
Remove the bottom section of the rear panel by loosening four screws. The black
plastic box containing PCB60 can now be opened. See
Insert a screwdriver at the center just below the cloth front (K) and wriggle up the
cloth front without damaging strip or cloth front. Push the cloth front to the right,
about one cm. Then pull out the cloth front carefully. See
For mounting of the cloth front, hold it straight onto the TV, placing it just a little
to the right. Make sure the clips fi t into the holes in the TV. Then carefully push it
to the left to make it fi t on the TV. It is easily felt if it has been misplaced.
Remove the upper rear panel (6 screws). Remove the lower rear panel (4 screws).
Remove the speaker front fabric. Remove the screw at the top of the speaker cabinet,
as viewed from the front. The speaker cabinet can now be pulled backwards.
When installing the speaker cabinet, the two rubber dampers must be fi tted on
the towers at the bottom of the speaker cabinet, and they must be fi tted into the
holes in the bottom of the main frame.
Carefully place the BeoVision Avant 32 DVD on its side.
Remove the 4 pieces of tape covering the holes in the bottom of the motorized
stand. Turn the motorized stand until the 4 holes in the bottom are aligned with
the screws. Unscrew the 4 screws to remove the motorized stand.
The aluminium sheet on the motorized stand is fi xed with double-sided adhesive
tape.
Dismantling, English
10. Use one hand to push
10.
12.
10.
6.1