B.Braun Aesculap favorita II Mode D'emploi page 7

Masquer les pouces Voir aussi pour Aesculap favorita II:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
The following recommendations should be followed
for satisfactory handling:
Ø
Each time before shearing, the cutter heads should
be oiled.
Ø
When the cutter heads are in regular use, dismantle
them every few days and clean them with a soft
cloth or brush. Clean very carefully between the
teeth.
Ø
After cleaning the cutter blades, oil them lightly (to
prevent rusting).
Ø
Prior to assembling, wipe off the sliding surfaces
with the palm to make sure that these parts are ab-
solutely clean.
Ø
The cutter head can cut properly only if there are no
hairs between the cutter blades.
Ø
Tighten the knurled screw only so far that the upper
cutter blade can still be moved with moderate pres-
sure from the side.
Ø
Cutter heads are changed while the machine is run-
ning. To do this, the lever on the side of the ma-
chine must be pressed.
Ø
To maintain the accuracy of cutting over a longer
period, a heavily soiled coat of the animal to be
sheared should be cleaned beforehand.
Ø
To ensure trouble-free cutting, it is advisable to
comb the animal thoroughly and to untangle mat-
ted parts.
Ø
The cutter heads can be professionally sharpened
several times. For this purpose, contact an
authorized repair shop.
5.
Storing
Keep the clipper in a dry place with oiled cutter heads
and cutter head holder.
6.
Important spares
When ordering spare parts please indicate the serial
number as well as the type of the clipper 20 (Fig. 1) to-
gether with the cataloque number of the spare re-
quired.
GT 604
Special oil for cutter heads
GT 605
Special gear grease
GT 104 614
Carbon 24
GT 104 803
Airfilter 4 (Favorita/Elektra)
GT 104 808
Oscillating lever 22
GT 104 244
Plastic sliding bar 23
GH 214 813
Airfilter 4 (EHMANN)
TA 004 662
Knurled screw 11
TA 004 663
Cylinder screw 14 for fixing pres-
sure plate 15 at the lower cutter
blade
GT 730 203
Plate spring 12
GT 730 201
Pressure plate of plastic 15
5

Publicité

Table des Matières
loading

Table des Matières