Napoleon Luxuria LVX38P2-1 Manuel Du Propriétaire page 27

Masquer les pouces Voir aussi pour Luxuria LVX38P2-1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Slide the GGA-1 into the appliance until outer glass panel makes contact with heat rail gasket. The glass
11.
surface should contact the heat rail at each end (Fig. 15). The GGA-1 must 'click' into latches when
secure. The GGA-1 must be retained by the latches and not open, if pulled. If GGA-1 does not smoothly
engage with latches, an adjustment may be required, see step 13.
important:
Ensure that the heat rail gasket is touching the both ends of the back of the outer glass as shown.
Heat Rail
Gasket
Outer Glass
SIDE VIEW
For longer appliances, the glass pieces may look slightly bowed (illustration not to scale) when the glass and
appliance are cold. This is normal and not a cause for concern. The glass will straighten and become flush
to the heat rail gasket as it becomes warm when the appliance is operating.
It is REQUIRED to have the gasket touching both ends of the outer glass.
WARNING
!
Normally there is no need to adjust the position of the heat rail. Contact your authorized Napoleon dealer before
attempting any adjustment of the heat rail.
Heat Rail
Gasket
Intermediate Glass
Outer Glass
The gasket MUST touch the back of
the outer glass at both ends.
maintenance
Heat rail
with gasket
Fig. 14
Fig. 15
27
W415-2036 / E / 05.10.22
EN

Publicité

Table des Matières
loading

Table des Matières