Recognising And Removing Interferences - Reiner ChronoDater Série Mode D'emploi

ChronoDater 920/922/925

4. Recognising and Removing Interferences

Display
No display
Please wait
Batteries empty, please
change
Insert Chipcard
Card inserted incorrectly!
Turn over
Please wait Printing
Warning 01
Warning 15 to 17
Warning 20
Warning 31
Printing is interrupted
44
Error cause
The device is not connected
to the mains
The device performs settings
The batteries for saving your
settings are empty
The Chipcard is not or incom-
pletely inserted
Printing is difficult or
blocked
The memory was overwritten
with default values
The Chipcard was not
inserted correctly
2
The housing flap is not
closed
Too-thick print media or
batch used.
In exceptions, the print roll
may block.
Remedy
Connect the included
f
mains adapter to the
ChronoDater and plug
the mains adapter into a
socket with the
matching mains voltage
Wait until the device is
f
ready for operation
Have the batteries
f
replaced by trained
specialists
Insert Chipcard
f
Turn over Chipcard
f
If this message appears
f
frequently, contact your
specialist vendor
Push [OK]
f
Insert matching
f
Chipcard correctly
Close the housing flap
f
correctly
Disconnect the mains
f
adapter plug and tip
the device backwards.
You will see a knurled
wheel on the bottom.
Turn it until the block is
relieved.