MRA 4025066163298 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
1 Holding plates
2 Nut covers
2 Clamp for 28/32mm handlebars
2 Nuts M6
2 Washers 12 x 6 x 1mm
2 Cylinder screws M6x40
4 Plastic discs 12x5x0.5mm
4 Fillister head screws, black M5x16mm
4 Elastic nuts M5
1 Edge protection strip with clamping sleeves
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Assemble the handlebar clamps with spacer sleeves on the handlebars (P1+P2).
3. Screw the nuts M6 onto the clamps (P2) from the rear.
4. Assemble the holding plates with the Allen screw M6x40mm and the black washers to the clamps
(P2 + P3).
5. When assembling the holding plates, lightly press the nut M6 into the clamp to allow the screw to
grip the nut.
6. Only tighten the screws gently. Apply the rubber nuts to the holding plates (P3). Align the holding
plates in the middle and at the correct angle to the motorcycle with the help of the MRA
windscreen.
7. Pay attention that the clamps are not pressing against the speedometer housing and the MRA
windscreen does not touch the expansion tank for the brakes and transmission.
8. When the holding brackets are correctly aligned, securely tighten the screws M6x40mm and apply
the cover cap to the clamps (P4).
9. Mount the MRA windscreen using the fillister head screws M6x10mm and the plastic washers onto
the holding plates and tighten the screws securely.
10. Apply the protective edge strip profile as shown in Figure 5. Cut off the rest if required.
11. Push the clamping sleeves over the ends of the protective edge strip and lightly compress them,
using a pair of pliers to secure the protective edge strip profile.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
KTM 1290 Super Duke R 2017-
Article No..
--- Allen key 3mm
Allen key 5mm
11341
10540
11118
10646
10559
11016
10635
10554
10629
---
3
Required tools