Preparing The Product For Use; Unpacking; Safely Disposing Of Packaging Material; Preparatory Work Before Installation - Stahl EC-94 Série Manuel D'instructions

6 Preparing the product for
use
Before carrying out any type of
intervention, read the "Safety rules"
chapter carefully in the product manual.

6.1 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
6.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Explosion-proof PTZ camera
• Sunshield
• Silicone sheath
• O-ring replacement part kit, hexagon socket set
screws
• Stopping plug
• Sealant
• Cable ties
• Separation barrier for installations according to UL/
CSA standards
• Instruction manual
6.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
14
6.4 Preparatory work before
installation
It is possible to install the unit with several brackets.
We strongly recommend using only approved
brackets and accessories during installation.

6.4.1 Methods of installation

The system can be installed only in a standard or
inverted position (ceiling mount). When installed
for inverted operation, the camera orientation and
controller functions are reconfigured for normal
operation through the system's software.
Hardware adjustment is not required for inverted
operation.
Fig. 5
MNTCMPXHDC_2038_EN