Service And Maintenance - Festool OF 1400 EQ-F Notice D'utilisation D'origine

8
9
Copying device
The copying device requires the angle arm WA-
OF [10-2] and the copier scanning set KT-OF,
consisting of a roller support [10-6] and three
copying rollers [10-7].
► Use the rotary knob [10-3] to tighten the
angle arm to the required height on the
threaded hole [10-1].
► Fit a copying roller to the roller support and
use the rotary knob [10-5] to tighten it on
the angle arm. Make sure that the copying
roller and the router have the same diame­
ter.
► The distance between the feeler roller and
the cutter axis can be adjusted by turning
the adjusting wheel [10-4].
10
8-1
8-2
10-2
10-3
8-3
10-4
10-5

10 Service and maintenance

Any maintenance or repair work that re­
quires opening of the motor or gear housing
should only be carried out by an authorised
Customer Service Centre (name supplied by
your dealer)!
► Maintenance or repair work carried out by
an unauthorised person can lead to the
wrong connection of the power cord or oth­
er components, which in turn can lead to
accidents with serious consequences.
To prevent accidents, always remove the
plug from the power supply socket before
carrying out any changes or maintenance
work on the tool!
► Do not use compressed air to clean the
electrical tool! Do not try to clean parts in­
side the tool in this way, as you could let
foreign objects in through the openings of
the tool housing.
Certain cleaning agents and solvents are
harmful to plastic parts.
► Some of these include, but are not limited
to: Gasoline, Acetone, Methyl Ethyl Ketone
(MEK), Carbonyl Chloride, cleaning solu­
tions containing Chlorine, Ammonia, and
household cleaners containing Ammonia.
10-1
10-6
WARNING
WARNING
CAUTION
English
10-7
15