Omega Lift Equipment 31500 Mode D'emploi page 3

Saddle Pad (10)
Saddle (9)
Pin (8)
Grease Fitting
Nipple (6)
Bearing (5)
Upright (4)
Nut, M8 (2)
Base (1)
Figure 1 - 31500 Nomenclature
! WARNING
• Study, understand, and follow all printed
materials provided with/on this product before use.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• Center load on saddle.
• Do not use to support or stabilize vehicle.
This stand is intended to provide partial
support of vehicle components during removal
and installation.
• Adequately support vehicle before starting
repairs.
• Use ONLY under a properly secured
automotive lift.
• Do not use adapters or accessories that are not
provided initially.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
Saddle Pad (10)
(7) Adjusting
Grease Fitting
Handle
Pin, D15mm (3)
(11) Threaded Rod
Pin, D11mm (2)
(3) Bolt, M8x55
3
Saddle (9)
Pin (8)
Nipple (6)
Bearing (5)
Base (1)
Figure 2 - 31501 Nomenclature
OPERATION
!
WARNING: This product should NEVER be used to
lift or lower a vehicle.
To Raise
1. Turn adjusting handle clockwise until saddle contacts load.
Be sure to center load on saddle.
2. On Model 31501, slight upward adjustment can be made
to the saddle height by pressing downward on the foot
pedal. This may or may not be necessary depending on the
application. It is provided as a means of making temporary
adjustments on load height without using your hands.
This leaves your hands free to engage, handle and control
the workpiece.
! WARNING: Do not lower overhead lift in order to
accommodate the stand. Contact with the desired
vehicle component shall only be done by means of the
vertical adjustments provided on the stand.
To Lower
!
WARNING: Make certain that all personnel are clear
of the load before lowering. Watch and control the
rate of descent of the load at all times.
To lower, simply turn adjusting handle counter-clockwise.
(7) Adjusting
Handle
(4) Upright
(14) Washer, M16
(15) C-clip
(11) Threaded Rod
(16) Foot Pedal
(12) Washer, M12
(13) C-clip