Cleaning And Maintenance; Safety Advice - Bartscher Regina Plus 40T Mode D'emploi

Instructions and advices
NOTE!
The best results can be achieved when coffee is prepared for at
least 20 or 30 cups at once.
Remove the filter basket and coffee grounds immediately after the
brewing process. Thanks to this the coffee's flavor is maintained.
WARNING! Danger of burns!
Elements of the filter basket and grounds are very hot.
During removal, use appropriate protective equipment!
•
Before starting the next batch of coffee, you should thoroughly rinse the coffee
brewer with cold water.
•
Any drops arising from removing the filter basket and the wet coffee grounds should
be wiped clean.
•
In order to re-heat cold coffee you should remove the filter basket and riser pipe
before connecting the device to the power.
•
The coffee machine can also be used to heat water. Fill the cleaned water container
with cold water; insert the riser pipe and cleaned filter basket. Turn on the device, as
in brewing coffee.
•
Set the ON/OFF switch to position „O" when the heating is finished.
•
Pull the power plug as soon as less than four cups of water are left in the water tank.
NOTE!
If the device will not be used, remove the riser pipe, otherwise it might get stuck
in the heating hole.

6. Cleaning and maintenance

6.1 Safety advice

o Before beginning with repair or cleaning works make sure the device has been
disconnected from power supply and has cooled down.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables and
the plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets.
Therefore, you must not use any kind of pressure water jet for cleaning the device!
- 31 -