Table Des Matières; Prepare Installation; Elect Installation Type - Broan Elite EW46 Série Manuel D'installation, D'utilisation Et D'entretien

1. P . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
REPARE INSTALLATION
2. S
ELECT INSTALLATION TYPE
3. B . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
UILD FRAMEWORK
4. I
NSTALL UPPER FLUE MOUNTING BRACKET
5. I ( -
NSTALL PLENUM NON DUCTED INSTALLATION ONLY
6. R
EMOVE GREASE FILTERS
7. A
DJUST THE HOOD MOUNTING BRACKETS
8. I . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
NSTALL THE HOOD
9. C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
ONNECT WIRING

1. PREPARE INSTALLATION

NOTE: Before proceeding to the installation, check the contents of the box. If
items are missing or damaged, contact the retailer.
Make sure that the following items are included:
- Hood
- Decorative flue assembly (lower and upper flues)
- Upper flue mounting bracket
- Aluminum grease filters (2)
- Installation instructions
- Parts bag: 6 M4 x 38 Phillips 9 mm round head mounting screws,
2 M4 x 12 Phillips 9 mm round head screws, 2 washers and
3 wire connectors
Parts sold separately:
- Ducts, elbows, wall and roof caps.
- Optional flue extension for ceilings of 9 ft. or more: models AEEW46SS
(stainless steel).
- Non-duct kit model ARKEW46, mandatory for non-ducted installation.
NOTE: During installation, protect countertop and/or cooktop.
2. SELECT INSTALLATION TYPE
When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
2.1 N -D I
ON UCTED NSTALLATION
The ARKEW46 non-duct kit is required for a non-ducted installation.
2.2 D I
UCTED NSTALLATION
Plan where and how the ductwork will be installed.
A straight, short duct run will allow the hood to perform most efficiently. Long duct
runs, elbows and transitions will reduce the performance of the hood. Use as few
of them as possible. Larger ducting may be required for longer duct runs.
Install wall or roof cap. Connect 6" round metal ductwork to cap and work back
towards the hood location. Use 2" metal foil duct tape to seal the joints.
2.3 A I
LL NSTALLATIONS
The minimum hood distance above cooktop is 24" . A maximum of 30" above
cooktop is recommended for best capture of cooking impurities.
Distances over 30" are at the installer and users discretion providing that ceiling
height and decorative flue length allow it.
NOTE: Ceilings of 9 ft. or more require flue extension model AEEW46SS (stainless
steel).
TABLE OF CONTENTS
. . . . . . . . . . . . . . . . . . . . . . . . . 3
(
DUCTED INSTALLATION ONLY
) . . . . . . . . . 4
. . . . . . . . . . . . . . . . . . . . . . . . . . 5
. . . . . . . . . . . . . . . . 5
10. D
UCT CONNECTION
11. P
REPARE THE DECORATIVE FLUE
12. I
NSTALL THE DECORATIVE FLUE
) 4 13. R
EINSTALL GREASE FILTERS
14. O . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
PERATION
15. C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
ARE
16. R
EPLACEMENT PARTS
17. W . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
ARRANTY
(1) D
HR0227A
WARNING
!
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
. . . . . . . . . . . . . . . . . . . . . . 8
. . . . . . . . . . . . . . . . . . . . . 8-9
. . . . . . . . . . . . . . . . . . . . . . . . . 9
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
ECORATIVE FLUE
(6) M4
ASSEMBLY
ROUND HEAD SCREWS
(2) M4
ROUND HEAD SCREWS
(2) W
(3) W
R
OOF CAP
D
ECORATIVE
FLUE
H
OOD
24"
MINIMUM ABOVE
COOKING SURFACE
HH0283A
(1) U
PPER FLUE
MOUNTING BRACKET
(2) G
REASE FILTERS
38 P
X HILLIPS
12 P
X HILLIPS
ASHERS
IRE CONNECTORS
6" R
OUND
DUCT
W
ALL
CAP
6" R
OUND
ELBOW