Arexx BS-510 Mode D'emploi page 51

Checking the drivers
- Check (at: Start > Configuration window > Devices and Printers) the
execution of RF-USB. Re-install the driver. Wait to connect the device
until the installation process commands you to do so!
E
- Check the correct installation of the driver and the PC-connection.
Check the entry 'USB@x' at the "Synchronisation" window of the
N
Multilogger Software and the accompanying firmware version of the
module. (Multilogger Software Menu – display section: Tools' section)
G
L
Checking the sensors
Insert batteries into the sensors. The sensors automatically will register
I
themselves to the software. Check the "Sensorlist" window at the
S Multilogger Software (Multilogger Software Menu – display section: Tools'
section). The sensors' list displays three columns:
H
Sensor name, Date and Time stamp for the most recent measurement
data and the referenced temperature value.
User manual for the Multilogger-Software
All user information for the Multilogger-Software may be found in the soft-
ware's help-section.
Unknown sensors
You can remove the unknown sensors with the tool
Tool"
RESET BS-510
Remove power and inside battery for about 20 sconds
WE ADVICE YOU TO REGULARLY UPDATE THE MULTILOGGER
SOFTWARE VISIT: WWW.AREXX.COM
APPENDIX
TIPS
51
"Erase Data Flash
.