Arexx BS-510 Mode D'emploi page 38

The BS-510 is a USB Multilogger receiver, the module receives
measurement data from the Multilogger sensors wirelessly and
prepares these data for further processing via a USB-entry at a PC.
The BS-510system provides us with an internal memory flashdata-
storage for measurement data during offline-periods at which the PC
is disconnected.
Application sample for the BS-510S
Let us assume you already installed the Multilogger software at your
PC and also inserted the batteries into your sensors. Now use the
included USB-cable to connect the BS-510 device to your PC.
The very first connection the PC will ask you to install is the USB-
driver for the BS-510 (RF_USB). In case the driver software has
been installed correctly and the BS-510has been connected,
the Multilogger software Synchronisation window will display
a 'USB@x' message and the firmware's module version.
In a next step the module will transfer the sensors' measurement
data to your PC. The Multilogger software will display this process
at the window "sensors list", which lists the most recent data for all
sensors. The Sensor list is under the Menu view.
The module will process incoming sensor data as long as it is
connected to a power supply. If the PC is disconnected or swit-
ched off, the system will store data in the internal data-flash
memory.
As soon as the PC-connection has been reactivated, the Multilogger
software will resume the data transfer from the flash memory to the
PC. This concept allows a continuous measurement data flow – even
if the PC is offline from time to time.
38
E
N
G
L
I
S
H