Electrical Safety - DeWalt DW079 Traduction De La Notice D'instructions Originale

EN GLI SH
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1–3)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
INTENDED USE
The DW079 rotary laser has been designed to
project laser lines to aid in professional applications.
The tool can be used both inside and outside for
horizontal (level) and vertical (plumb) alignment. The
tool can also produce a stationary laser dot that can
be directed manually to establish or transfer a mark.
The applications range from drop-ceiling installation
and wall layout to foundation leveling and deck
building.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This laser is a professional tool. DO NOT let children
come into contact with the unit. Supervision is
required when inexperienced operators use this
laser.
LASER (FIG. 1)
a. Hatch door
b. Carrying handle
c. Latch
d. Rotary laser head
e. Power button
f. Speed/rotation button
g. Scan mode button
h. Directional arrow: up
i. Directional arrow: down
j. Power LED indicator
k. X-axis LED indicator
l. Y-axis LED indicator
m. Private mode LED indicator
REMOTE CONTROL (FIG. 1)
n. Power button
o. Manual mode button
p. Directional arrows: up/down
q. Directional arrows: left/right
r. Speed/rotation button
s. Scan mode button
t. Power LED indicator
44
u. Manual mode LED indicator
CHARGER (FIG. 2)
v. Battery pack
w. Release buttons
x. Charger
y. Charging indicator (red)
z. Battery cap
WALL MOUNT (FIG. 3)
aa. Mounting base
bb. Base mounting hole
cc. Mounting knob
dd. Scale
ee. Clamp locking knob
ff. Mounting holes
gg. Base leveling knob
hh. Locking knob
ii. Adjustment knob

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
WARNING: 115 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.