Transmission; Clothing; Use - Texas Hobby 300 Manuel De L'utilisateur

Transmission

Transmission is not greased from the factory !!
Fill with grease until it runs out of the filling hole when the machine is placed in
horizontal position.
How to add grease the first time :
Dismount the sparkplughcap on the engine.
-
Add grease to the transmission.
-
Place the greasebottle in a bucket with hot water. This will make the grease thinner.
-
And thereby easier to fill in the transmission.
Only cut a little of the tip on the greasebottle.
Fill grease on the transmission, until it runs out of the fillinghole, when the machine
is placed in horizontal position.
Activate the clutchhandle and pull 3 times, this will distribute the grease in the
-
transmission.
Add more grease, until the transmission is full.
-
Mount and tighten the bolt.
-
Mount the sparkplughcap on the engine.
-
Figur 6

Clothing

When working with the tiller, wear close-fitting work clothes, sturdy work gloves, hearing
protection and boots with non-skid soles, and steel nose is compulsory.

Use

Clean the area of all foreign items before use. Stone, glass, branches, etc. can damage
the tiller. Check that all bolts on the tiller are tightened.
Start:
Place the throttle handle on choker/full throttle.
Follow the guide in the user manual to start.
Stop:
Place the throttle handle on minimum throttle.
Follow the guide in the user manual to stop.
The tiller is designed to cultivate vegetablegardens and flowerbeds. Furthermore the
machine can be equipped with different accessories.
Read the instructions carefully and be confident how to start and stop the engine.
When the clutchcable, on the right side is pressed down, the blades are activated. It is
important that the handle is pressed fully down to the handlebar. This will secure an
10