Bimar HC507 Mode D'emploi page 13

 If the electric cord is damaged, it has to be replaced by the
supplier or an authorized service center or aqualified person, to
avoid any risks.
 This unit is not intended to be operated by an external timer or
remote-control system to avoid the risk of fire if the appliance is
covered or incorrectly positioned. Check that other high-
absorption devices are not connected to the same electrical line.
 The appliance must not be placed immediately below a power
outlet.
 Do not use this appliance near a bathtub, shower or pool.
INSTALLATION
 After removing the packing materials, check the integrity of the heater; if you are
unsure, do not use it and ask for professional help. The packaging materials (plastic
bags, polystyrene foam, nails, etc.) must be kept out the reach of children because
they are potential sources of danger.
 Before connecting the appliance, check that the voltage shown on the data plate
matches that of your electricity. In the event of incompatibility between the electric
out let and the plug of the heater, have the out let replaced with another more
suitable type by qualified personnel, who will make sure that the section of the wires
of the outlet is appropriate forthe absorbed power of theheater.Ensure that other
appliances with high absorption are not connected to the power line to avoid
overloads and fire hazards. Generally, adapters and / orextensions are not
recommended; If their use is indispensable, they must comply with current safety
regulations and their current rating (ampere) should not be lower than the maximum
level of the appliance
 The appliance can be used if it is fixed to the wall (in a fixed position), the surface of
which must be flat, with no bumps, stable and heat-resistant (Do not place or lean the
panel on the floor). It can beplaced on the floor by using the designated stands
supplied.
 Do not use this appliance near a bathtub, shower or sink; in order to prevent drops of
water falling on the appliance and the accidental dropping of the device into the
water. If this happens, do not immerse your hand, but first turn off the power socket
at the main power switch and only then remove the plug from the socket. Carefully
clean the plug and the socket and after that turn the power back on. Put plug back
into the socket, and then use the appliance. If in doubt, contact qualified personnel.
Wall installation
For this type of installation, use the plugs provided (do not use the support feet) and
proceed as follows:
 Position the appliance far from other heat sources, flammable materials (curtains,
tapestries, etc.), flammable gas or explosive material (spray cans) and materials that
13