Falcon 110 Instructions D'utilisation Et D'installation page 31

The cooker should not be placed on a base.
The hotplate surround should be level with, or above, any
adjacent work surface. Above hotplate level a gap of
75mm should be left between each side of the cooker and
any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles) this can be reduced to 25mm.
A minimum space of 650mm is required between the top
of the hotplate and a horizontal combustible surface.
Any cooker hood should be installed in accordance with
the hood manufacturer's instructions.
For safety reasons curtains must not be fitted immediately
behind the cooker.
We recommend a gap of 1110mm between units to allow
for moving the cooker. If a flush fit is required, fit the
cooker up to the unit at one side then fit the unit the other
side.
A clearance of 130mm is required if the cooker is near a
corner of the kitchen to allow the oven doors to open.
Unpacking the Cooker
The cooker is very heavy. Take great care. We recom-
mend two people manoeuvre the cooker. Ensure that the
floor covering is firmly fixed, or removed to prevent it being
disturbed when moving the cooker around.
Do not take any packaging off the cooker until it is directly
in front of the place it is to be installed (unless it will not fit
through a door in its outer packaging).
See the loose unpacking sheet.
Levelling
You are recommended to use a spirit level on a shelf in
one of the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as dam-
age may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust
the height of the rear of the cooker use the levelling tool
supplied to turn the adjusting nuts at the front bottom cor-
ners of the cooker.
Adjust the height of the front roller to level the cooker.
Turn clockwise to raise the cooker and anticlockwise to
lower.
When you are satisfied with the height and level raise the
front of the cooker by one turn of the front roller adjuster.
Screw down the front feet to meet the floor. Screw the
front roller adjuster anticlockwise to raise the front roller so
that the front of the cooker is supported on the feet, not the
front roller, to prevent accidental movement of the cooker.
Leave the levelling tool on the adjuster with the handle of
the tool facing the rear of the cooker, so that the customer
can use it if they wish to move the cooker.
Replace the drawer by locating on side runners and push
in.
Fit the Handles (some models only)
Remove the 4mm Allen screws from the doors with the
hexagon key tool. Use the screws to fit the door handles.
The handles should be above the fixings.
Remove the 4mm Allen screws from the top corners of the
facia and fix the front handrail in position.
Fitting the splash back (optional - some
models only)
view from the rear of the cooker
31
English