Control Panel And Oven Doors - Falcon 110 Instructions D'utilisation Et D'installation

English
("Cleaning for burned-on spills"). If you accidentally melt
anything on the cooking or if you spill foods with a high
sugar content (preserves, tomato sauce, etc.), REMOVE
the spill IMMEDIATELY with a razor scraper, while the unit
is still hot. IMPORTANT: Use an oven glove to protect
your hand from potential burns. Scrape the major spill or
melted material from the cooking zone and push into a
cold area. Then, turn the unit "OFF" and allow to cool be-
fore cleaning further. After the cooking surface cools down
and the heat indicator lights go off, use the daily care pro-
cedure as outlined above.
Cleaning for burned-on spills
Be sure that the heat indicator lights are off and the hob is
cool. Remove excess burned-on substance with a single-
edged razor scraper. Hold the scraper at approximately a
30° angle to the surface and scrape off the burned-on mat-
ter as you would scrape paint off of a window.
IMPORTANT: Take care when using a sharp scraper.
When you have removed as much as possible with the
scraper clean using the daily care procedure as described
above.
To remove metal rub-off
Sliding pans on the hob - especially aluminium or copper
pans can leave marks on the surface. These marks often
appear like scratches, but can be easily removed using
the procedure described above for cleaning spills. If the
rub-off marks are especially stubborn, use the cleaning
cream together with the razor scraper, using the technique
described above.
Grill
The grill pan and grid should be washed in hot soapy wa-
ter. After grilling meats or any foods that soil, leave to soak
for a few minutes in the sink immediately after use. Stub-
born particles may be removed from the grid by using a
nylon brush.

Control Panel and Oven Doors

Avoid using any abrasive cleaners including cream
cleaners, on brushed Stainless Steel surfaces. For
best results liquid detergents should be used.
The control panel and control knobs should only be
cleaned with a soft cloth wrung out in clean hot soapy wa-
ter - but take care that no surplus water seeps into the
appliance. Wipe with a clean dampened cloth then polish
with a dry cloth. The oven doors should only be cleaned
with a soft cloth wrung out in clean hot soapy water.
Stainless Steel Cookers with window doors
On some models the oven door front panel can be taken
off so that the glass panels can be cleaned. If the top edge
of the oven door of your cooker has a line of holes and
there are screws in the side edges then it can be taken
apart for cleaning.
Move the cooker forward to gain access to the sides (see
the 'Moving the cooker' section of these instructions).
Open the oven door slightly and remove the front panel
fixing screws from the door sides (two each side).
Carefully lift off the outer door panel. The inside face of the
glass panels can now be cleaned - take care not to disturb
or wet the door insulation. Please note that the door is tri-
ple glazed but the inner two panels are fixed and should
not be separated. After cleaning carefully refit the outer
door panel and replace the side fixing screws.
Oven
The ovens have removable panels that have been coated
with a special enamel that partly cleans itself. This does
not stop all marks on the lining, but helps to reduce the
amount of manual cleaning needed.
The Cook & Clean panels work better above 200°C. If
you do most of your cooking below this temperature, oc-
casionally remove the panels and wipe with a lint free
cloth and hot soapy water. The panels should then be
dried and replaced and the oven heated at 200°C for
about one hour. This will ensure the Cook & Clean pan-
els are working effectively.
Don't use steel wool or any other materials that will
scratch the surface. Don't use oven cleaning pads.
Removing the Oven Linings
Some of the lining panels can be removed for cleaning
and for cleaning behind. Remove the shelves first.
The right hand fanned oven has a removable oven roof -
slide the roof liner forward and remove.
The side panels of either oven can be removed. Each side
of the oven is fixed with four fixing screws. You don't have
to remove the screws to remove the oven linings. Lift each
side panel upwards and they will slide off the screws.
Then pull them forwards.
26
some window doors only