Connections Diagram - CTX 70692 Manuel D'installation

To access the programming menu. (Press and hold down simultaneously for at least 3
seconds).
+
To start and stop the pump.
To disable the display notification in case of active level alarm condition (only alarm function),
flow alarm condition and memory.
In programming mode it functions as "enter", to confirm the access and the changes to the
various menu levels.
To "escape" the various menu levels. Before exiting the programming mode you will be
prompted to save the changes.
Prolonged pressure displays the screen for the flow sensor calibration.
To scroll the menus or change the parameters in programming mode.
Prolonged pressure enables the priming.
Green LED flashes while dosing.
Red LED turns on in case of various alarm conditions.

CONNECTIONS DIAGRAM

2-wire PT100 connection diagram
EM00136493
Control panel – KOMPACT DRP
+ to change the contrast.
rev. 1.0 EN
Electrical connections
3-wire PT100 connection diagram
1
PT100 temperature probe input (see
2
the connection diagram)
3
4 Not Used
5 Pole -
6 Pole +
7
Level control probe input
8
9
Remote control input (start-stop)
10
11
Flow sensor input
12
pH or Redox
probe input ( pre-
wired with BNC )
4