Liquid Propane (Lp) Safety Information - Landmann 42135 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Liquid Propane (LP) Safety Information

Please review the below guidelines and safety information when using Liquid Propane (LP) gas.
General Information
lb. LP gas cylinder.
for use on this grill, provided that it is compatible
with the grill's retention means (tank tray bolt).
for local LP gas supply.
CANNOT be converted to natural gas.
DO NOT attempt to convert this grill with a
different gas type.
Safety Information
collect in low areas and resist dispersion.
stored in an upright position.
roughly.
DO NOT use a damaged LP cylinder. A dented or
rusty LP cylinder or an LP cylinder with a damaged
valve may be hazardous and should be replaced
with a new cylinder immediately.
ALWAYS close the cylinder valve after use.
ALWAYS close the cylinder valve when
disconnecting the regulator.
ALWAYS treat possible empty LP cylinders with
the same care as a full LP cylinder. There may
still be gas pressure inside a possible empty LP
cylinder.
NEVER store or transport an LP cylinder where the
temperature can reach 125ºF.
DO NOT store disconnected LP cylinders in a
building, garage or other enclosed areas.
make sure to keep both the grill and the cylinder in
an outdoor area with good ventilation.
ALWAYS leak test the LP cylinder connection to
the regulator whenever changing LP cylinders.
Installation of LP Cylinder
1. Maker sure all burner controls are in the
position.
2. Open the cabinet door.
3. Carefully position in the large hole on the bottom
panel.
4. To secure the LP cylinder in place, screw the tank
holding tray bolt through the bottom section of the
LP cylinder.
5. Attach the regulator to the cylinder by carefully
HAND TIGHTENING only.
6. NEVER use a wrench or other tool to tighten this
connection.
7. Observe all governing codes and ordinances.
Important
The United States LP gas appliance installation must
conform with local codes and ordinances. In the
absence of local codes, appliance installation must
conform with either the National Fuel Gas Code, ANSI
Z223.1/NFPA54, Natural Gas and Propane Appliance
code, CSA B149.1, or Propane Storage and Handling
Code, B149.2, as applicable.
For Canada, installation of this grill must comply with
local codes and/or Standard CSA-B149.2 (Propane
Storage and Handling Code).
5
OFF

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

42211

Table des Matières