Reading Recorded Measurements; Special Functions; Auto On/Off; Buzzer On/Off (C.a 6412 And C.a 6415) - Chauvin Arnoux C.A 6410 Notice De Fonctionnement

Press sequence ON + A to exit the instrument from memory mode (the MEM symbol
disappears from the display). If the instrument is switched off without memory mode
being exited, this configuration will be saved.
The instrument will therefore automatically reset to memory mode when it is next
switched on again.
Unless the memory is reset to zero, all the recordings are saved even after the
instrument is switched off or the battery disconnected (instrument OFF).

Reading recorded measurements

A short press on ON + MEM allows you to consult the memory.
MR
The symbol is displayed, as well as the number of the recording shown.
if ON + MEM are pressed and held for 6 seconds the memory will be reset to
zero.
To display the values recorded in memory press the Ω Ω Ω Ω Ω button (subquent recordings)
and A (previous recordings).
The last digit of the recording number flashes to show that you are in read mode.
OFF (instrument off) allows the user to exit read memory mode.

SPECIAL FUNCTIONS

Auto ON/OFF

Your clamp is fitted with a battery system for economising battery power.
After approximately 5 minutes operation of the battery, if no button on the clamp has
been pressed, the instrument switches off automatically. 15 seconds before switching
off, a short beep warns the user, whilst the display starts to flash.
Auto Off can be deactivated by pressing the sequence ON + HOLD. In this case, the
instrument operates continuously (the symbol
will only switch off when the user presses the OFF button.
Continuous operation is cancelled when the instrument is switched off.
Buzzer ON/OFF (models C.A 6412 and C.A 6415 only)
Your clamp is fitted with a powerful buzzer whose different beeps indicate the state of
the instrument (see: Table of buzzer operation in Appendix).
If necessary, the buzzer operation can be switched OFF by pressing the sequence
ON + Ω Ω Ω Ω Ω . In this case the
This deactivation of the buzzer will be saved on models, even after the instrument
is switched off. Press ON + Ω Ω Ω Ω Ω again to switch on the buzzer again (the
will appear again).
P is displayed) and the instrument
symbol disappears.
37
symbol