Assembling The Welding Machine - CEA COMPACT 364 Manuel D'instructions

Assembling the welding machine

The standard composition of this welding installation consists
of:
• COMPACT 364 generator.
• Ground lead (optional).
The supply also includes the rear wheels for moving the weld-
er, a chain for securing the gas cylinder to the cylinder trolley,
a handle for moving the machine by hand and two eyebolts for
lifting the machine.
Perform the following operations before using the machine:
• Remove the welding generator and all relative accessories
and components from the packaging.
• Check that the welding apparatus is in good condition, other-
wise immediately inform the retailer or distributor.
• Check that all ventilation grilles are open and that no objects
obstruct the free passage of air.
• Assemble the machine as shown in figure A.
FIG. A
Model
Three-phase power supply 50/60 Hz
Mains supply: Z
max
Power input @ I Max
2
Delayed fuse (I @ 60%)
2
Power factor / cosφ
Maximum efficiency degree
Open circuit voltage (max)
№ of switch positions
Current range
Duty cycle @ 100% (40°C)
Duty cycle @ 60% (40°C)
Duty cycle @ 35% (40°C)
Wire diameter
Standards
Protection class
Insulation class
Dimensions
Weight
(*) IMPORTANT:
• This plant meets the requirements laid down in the EN/IEC 61000-
3-12 standard on harmonic currents.
• This system, tested according to EN/IEC 61000-3-3, meets the re-
quirements of EN/IEC 61000-3-11.
9
Table 1
COMPACT 364
V 230/400
Ω (*)
kVA 17,3
A 25/20
0,96
η 0,66
V 18,5 ÷ 45
14
A 45 ÷ 350
A 200
A 260
A 350
mm 0,6 ÷ 1,2
IEC 60974-1
IEC 60974-5
IEC 60974-10
IP 23 S
H
mm 860-540-790
kg 83