How To Lift Up The System; Assembling The Welding Machine; Installation - CEA Compact 270 Manuel D'instructions

eded, an overheat cut-off occurs to protect the components
around the welder from dangerous overheating. The yellow
thermostat LED located on the machine rack panel lights up
when the overheating protection trips. After several minutes
the overheat cut-off rearms automatically (Yellow LED off) and
the welder is ready for use again.

How to lift up the system

Before lifting the unit, open the bag containing the eyebolts
(attached to machine), remove the two eyebolts complete with
fibre washers and mount them on the upper part of the cover.
IMPORTANT: Only lift the unit using the two eyebolts.
The wire-feeder has a handle and a hook so that it can be hung
up.
NOTE: The lifting and transporting devices conform with Euro-
pean regulations. Do not use other equipment to lift or tran-
sport the feeder.

Assembling the welding machine

The standard composition of this welding installation consists
of:
• COMPACT 270 o 310 o 360 generator;
• Ground lead integrated with the machine 3 m long (COM-
PACT 310-360: optional);
The supply also includes the front and rear wheels for moving
the welder, a chain for securing the gas cylinder to the cylinder
trolley, a handle for moving the machine by hand and two eye-
bolts for lifting the machine.
Perform the following operations before using the machine:
• Remove the welding generator and all relative accessories
and components from the packaging;
• Check that the welding apparatus is in good condition, othe-
rwise immediately inform the retailer or distributor;
Fig. A
• Check that all ventilation grilles are open and that no objects
obstruct the free passage of air;
• Assemble the machine as shown in figure A.

Installation

Select the location of the machine to ensure satisfactory and
reliable service. Before installing the welding set the user must
take into account possible electromagnetic problems of the
working area. In particular, we suggest installing the equipment
away from:
• signalling, control and telephone cables;
• radiotelevision transmitters and receivers;
• computers or controlling and measuring instrument;
• safety and protection devices.
The welder must not be rested on a slant of more than 10°.
These welding machines are cooled through air forced-circula-
tion. That is why they must be disposed to facilitate the suction
and the emission of air through the slots of the frame.
The welding unit is characterized by the following classes:
• IP 23 protection class indicates that the generator can be
used in both interior and exterior environments;
• The "S" usage class indicates that the generator can be
employed in environments with a high risk of electrical
shocks.
9
2000H917