Corrective Action - GBC AutoUltima Pro Manuel D'utilisation

AutoUltima Pro – Troubleshooting
Symptoms
No power switch, does not illuminate when
in on position
Machine does not respond after pressing
standby button
Faint lines across the document
Cloudy lamination
Wavy lamination
Unsatisfactory adhesion to media
Feeder does not feed document
Document is skewed in film
Feeder picks multiple documents
Wrinkles in document
12
Possible cause
Power cord is not plugged
into live power outlet
Circuit breaker has tripped
Cover is open
No paper in feeder
Idler bar assembly
not latched
Document collection tray
is not fully inserted
Main power switched off
Low film
Machine is not fully warm
Incorrect film setting
Insufficient heat
Media not compatible
Media not compatible
with feeder
Paper is not fully inserted
to feeder
Feeder side guides
not set correctly
Static electricity on media, or
media is stuck together
EZ Load levers not closed

Corrective action

Plug into live outlet
Reset circuit breaker at
rear of machine
Close cover
Insert paper
Latch idler bar levers
Fully insert document
into exit tray
Turn on power
Load new film
Allow time to warm up
Select correct film setting
Verify correct film setting
Media is not suitable
for thermal lamination
Manually feed single
sheets
Fully insert paper to
feeder
Adjust feeder side guides
to paper size
Fan paper and replace
in feeder
Close EZ Load Levers