Using The Smartclean System - Philips S99 Série Mode D'emploi

ENGLISH
26

Using the SmartClean system

Always make sure to shake excess water off the
shaver before you place it in the SmartClean.
1 Hold the shaver upside down above the holder.
Make sure the front of the shaver points
towards the SmartClean system.
2 Place the shaver in the holder (1), tilt the
shaver backwards (2) and press down the top
cap to connect the shaver ('click') (3).
, The battery symbol and the on/off button start
to flash, which indicates that the shaver
is charging.
3 Press the on/off button on the SmartClean
system to start the cleaning program.
, The on/off button and the rinsing symbol both
light up continuously.
Note: The rinsing phase takes approx. 10 minutes.
Note: The progress bar shows the progress of the
rinsing phase.
, During the drying phase, the drying symbol lights
up continuously.
Note: The drying phase takes approx. 4 hours.
Note: The progress bar shows the progress of the drying
phase.