CyberPower Professional Rackmount Série Manuel D'utilisation page 8

LCD SETUP FUCTIONS
General Mode
a. Press the "Display-Toggle" button to check the UPS status:
b. Press and hold the Display-toggle button for 4 seconds:
If the machine is in the Battery Mode with active alarm, it will become silent.
If the machine is in the Line Mode, a self- diagnostic test will take place.
c. If the Display-toggle button remains untouched for over 30 seconds, the LCD backlight will turn off automatically.
Set-up Mode
Step 1: Hold the Display-toggle button for 10 seconds to enter the UPS Set-Up Mode.
Step 2: By pressing the Display toggle, users can switch between setup functions. Some User Configurable functions
are as follows:
a. Sensitivity: Set the level of tolerance for UPS. Increase the UPS compatibility for local utility power condition.
- High: The UPS will turn to battery power more often to provide the steady power supply to the connected
equipment.
- Low: The UPS will tolerate more fluctuations and turn to battery power less often.
b. Voltage Mode: The AC output voltage on battery mode. There are 3 different settings (220,230,240).
These programmable items are sorted by unit as in the following table:
Step 3: Press and hold the display-toggle button for 4 seconds. When the icons blink, the value of each item can be
changed by slightly pressing the toggle.
Step 4: To save the value and return to general mode, press and hold the toggle for 4 seconds.
Note! If the machine is left idle for over 30 seconds during setup, it will turn off the backlight and return to general mode
automatically.
Note! If user wants to return to the general mode without saving changes, there are two methods:
(1) Wait for the backlight display to turn off, or,
(2) By pressing and holding the "Display-toggle key for 10 seconds.
Items
Input Voltage
Output Voltage
Load Capacity
Battery Capacity
Estimated Runtime
Items
Sensitivity
Voltage Mode (220/230/240)
Firmware Version
Unit
V
V
%
%
Min
Unit
-
V
-
7