Bartscher 1365T3 Manuel D'utilisation page 35


Check the power cord regularly for damage. Do not use the
device if the power cord is damaged. If this cable is damaged, it
must be replaced by customer service or a qualified electrician in
order to avoid dangers.

The supply cable must be disconnected from the socket
only by pulling the plug.

Never carry or lift the device by the supply cable.

In any case do not open the device housing. In case of
electrical or mechanical modifications the electric shock
hazard will occur.

Do not use any acid agents and make sure no water ingresses
the device.

Never operate the device with moist hands or standing on wet
floor.

Remove the plug from its socket:
when the device is not used,
-
in case of anomalies during operation,
-
before cleaning.
-
HOT SURFACE! Burn hazard!
To avoid the hazard results please follow the safety instructions
below.

During normal use, the condenser and compressor surfaces
may be hot. To avoid burning your palm or hands, do not touch
them with your bare hands. Wear protective gloves!
- 31 -