Weidmüller WAVEANALOG PRO RTD Notice D'utilisation page 21

3. Configuring the device
3.1 Tools
A screwdriver with a 2.5 mm blade is required to set the device,
and to connect the conductors to the terminals.
3.2 Open the device
Remove the connector Press the lock lightly
on both sides of the housing to unlock it (1),
remove the upper part of the housing and the
electronics (2).
3.3 Settings
Set input and output ranges, minimum input
values and measuring span via the DIP switches
SW1 and SW2 according to the following tables.
The potentiometers Span (gain) and Zero (offset)
can be activated by the switch SW1/8, accessible
from the front below the cover (3), to finely
calibrate the gain and offset
Warning! A screwdriver, correctly insulated
against the input voltage, must be
used when making fine adjustments
via the potentiometers at the front of
the module.
2
1
SW2
SW1
3
Zero
Span
1
19 19