Blackmagic Design H.264 Pro Recorder Manuel D'installation Et D'utilisation page 12

Click the "+" button next to the Description to add it to the automatic Name field. Click the "+"
button next to any of the other fields that you wish to add to the Name field.
‚ You can increment the value in each of these fields by clicking on the corresponding
clapper board icon. Alternatively you can type directly in to any field to customize its
name and number.
‚ The text in the automatic Name field will be applied to the clip(s) which are about to
be captured.
‚ Click the "star" icon next to the Name field if you want to log the clip as a favorite.
‚ Click the "!" icon next to the Name field if you wish a clip name confirmation prompt
to appear before every capture. This will provide you with the chance to change the
clip name.
Set which two audio channels are to be captured and then click the "Capture" button to start
recording.
Set the desired audio channels to be captured.
To end capture, click the "Capture" button again to automatically keep the clip. Alternatively
press the "Esc" key if you want to be prompted to delete or save the clip.
Click the "Capture" button to commence recording.
The captured clips will be added to the Media List.
Logging Clips
Ensure an RS-422 serial cable is connected between your H.264 Pro Recorder and the deck.
The Remote/Local switch must be set to Remote on the deck so you can use the transport
controls in Media Express. Use the standard j, k, l shortcut keys to shuttle backwards, pause
and shuttle forwards on the deck.
Click the Mark In button to mark the In point, or use the shortcut key
Click the Mark Out button to mark the Out point, or use the shortcut key
Click the Log Clip button to log the clip, or use the shortcut key
in the Media List with a red X in its icon to indicate the media is offline.
.
i
.
o
. The entry should now appear
p
Blackmagic Media Express 12