FIG. 3
4.2
FRONT GLASS REMOVAL
FOR WALL MOUNT, PARTIAL RECESS AND MANTEL INSTALLED APPLIANCE ONLY:
A.
Remove the 2 screws from the top of the appliance, as shown below.
B.
Have two people, lift the glass up and away from the appliance, holding the glass vertical not fl at while
carrying. Place the glass face down onto a soft, non-abrasive surface, careful not to fl ex the glass.
C.
Install the crystal embers, refer to "CRYSTAL EMBER INSTALLATION" section. Install the front glass
by aligning with the pins on the appliance. This ensures the touch display panel performs properly.
4.3
CRYSTAL EMBER INSTALLATION
The glass front must be removed and the appliance must be secured in its fi nal location before the crystal
embers are installed.
A.
Carefully place crystal embers into the bottom media tray on the
front of the appliance as illustrated. Apply an even layer from side to
side.
17
EN
W415-1542 / C / 01.13.16