Maintenance; Preparation For Maintenance; Remote Battery Installation - Napoleon NEFL32FH Instructions D'installation Et D'opération

6.0 MAINTENANCE

ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE
PERFORMING ANY CLEANING, MAINTENANCE OR RELOCATION OF THIS ELECTRIC APPLIANCE.
TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE
DO NOT INSTALL REPLACEMENT LAMPS THAT EXCEED SPECIFIED MAXIMUM WATTS.
THE HALOGEN LAMPS IN YOUR APPLIANCE CAN BECOME EXTREMELY HOT. ALLOW AT LEAST
10 MINUTES BETWEEN TURNING OFF THE APPLIANCE AND REMOVING THE LAMPS TO AVOID
DO NOT HANDLE THE LAMP WITH BARE FINGERS, OILS FROM YOUR SKIN WILL DAMAGE THE
LAMPS WHEY THEY HEAT UP. USE GLOVES OR A CLEAN DRY CLOTH WHEN HANDLING LAMPS.
6.1

REMOTE BATTERY INSTALLATION

NOTE: The remote control has a removable plastic tab to prolong the battery life while shipping,
remove the tab for the remote control to function.
1. To replace the existing battery remove the
battery holder.
2. To remove the battery holder turn remote onto
rear side and press the left side leaver towards
the center while pulling the battery holder out
using the slot provided.
3. Replace existing battery, type CR 2025, with a
new battery and reinstall the battery holder into
the remote by sliding it into position, as shown.
NOTE: The remote control must remain within 5 meters or 17 feet of the appliance to be effective, this
range may be reduced when battery power is depleted.
!

PREPARATION FOR MAINTENANCE

CIRCUIT BREAKER TO ELECTRIC APPLIANCE RECEPTACLE.
ACCIDENTAL BURNS.
WARNING
BATTERY (CR 2025)
BATTERY HOLDER
19
EN
REMOTE
(REAR SIDE)
W415-1542 / C / 01.13.16