Finishing; Glass Front Removal; Crystal Ember Installation - Napoleon NEFV38H Instructions D'installation Et D'opération

4.0 FINISHING

POWER SUPPLY SERVICE MUST BE COMPLETED PRIOR TO FINISHING TO AVOID
HEAT VENTS AND AIR OPENINGS CANNOT BE COVERED IN ANY CIRCUMSTANCES.
4.2

GLASS FRONT REMOVAL

FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRES OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE FRONT GLASS IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
THE TOAUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
A. Remove the 2 bottom screws off the appliance.
B. Tilt the glass front away from the unit. Slightly pull down on the
glass to release from the top catch.
C. Remove and place on a soft non-abrasive surface, as shown in
the illustration.
D. Reverse steps to reinstall the glass front.
4.1

CRYSTAL EMBER INSTALLATION

Glass front must be removed and the appliance must be mounted in its fi nal location before the crystal embers
are installed.
A. CLEAN CRYSTAL MEDIA: Crystal embers may have a fi ne oil
residue that needs to be cleaned prior to installation. Clean the
crystal with mild dish soap, drain, rinse thoroughly and dry before
placing into the tray.
B. Carefully place crystal embers into the bottom tray on the front of
the appliance as illustrated. Apply an even layer from side to side.
!
RECONSTRUCTION.
!
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
WARNING
WARNING
GLASS FRONT
13
75.1
SIDE VIEW
2 SCREWS
W415-1352 / 08.19.14
EN