Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Part names and functions
Access Point
A
A LED indicator
B microSD card slot
C MSETUPN
Access point LED indicator
You can use the LED indicator to confirm the access point's status.
Access point LED indicator
Off
Amber, lit
Amber, blinking quickly
Green, lit
Green, blinking slowly
Green, blinking quickly
Green, lit « Amber, lit
(alternating)
Red, lit
*1
You can configure the access point so that its LED indicator does not light during normal
operation. For more information, refer to the User's Guide (page 31).
*2
It may take some time for the access point to finish starting up.
For assistance, visit www.panasonic.ca/english/support
HN7051C_(en_en)_0319_ver.040.pdf
B
C
D
D DC jack
E LAN jack
F Reset button
Status
No power, or LED indicator is turned off
Power on until start up completed
IP address is not obtained, or Ethernet cable is not
connected to the router
Power is on (normal operations)
completed for the camera or mobile device
Registration mode, updating
Obtaining an IP address, or accessing a microSD card
*2
Starting up
Registration failed
17
Setup
E
F
*1
*1
, or registration
*1
17
2018/03/19
19:00:12
Publicité
Chapitres
Table des Matières
