Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setup
Installing the outdoor camera
1
Open the interface cover (A), and then
slide the power slide switch to ON (B) .
2
Close the interface cover (C).
3
Secure the safety wire ring to the camera
nut of the camera using a driver (D), and
then pass the safety wire through the ring
of the safety wire ring (E).
4
5
1
3
Important:
R Make sure to close the interface
cover securely. Weatherproofness
cannot be assured if the interface
cover is open.
For assistance, visit www.panasonic.ca/english/support
28
HN7051C_(en_en)_0319_ver.040.pdf
4
Drive the wall mounting screws into the
wall.
1
2
Note:
R Use the following template when
2
28
Longer than 25 mm (1 inch)
Space 2.8 mm (
1
/
inches)
8
1
2
determining the location of the screw
holes.
25.4 mm
(1 inch)
2018/03/19
19:00:12
Publicité
Chapitres
Table des Matières
