Connecting The Power Cord; Connecting The Speakers; Attaching The Ferrite Core - Pioneer PDP-5000EX Mode D'emploi

Preparation
06

Connecting the power cord

AC IN
NOTE
• When not using this unit for extended periods, disconnect the power cord from its outlet.

Connecting the speakers

This unit is equipped with speaker output terminals. Consult
the accompanying illustration when connecting your own
speakers.
NOTE
• When connecting speakers, be sure to connect the
speaker's positive (+) and negative (–) terminals to the same
terminals on this unit. Proper sound will not be produced if
the (+) and (–) polarities are not connected correctly.
• This unit supports the use of speakers with 8 Ω to 16 Ω
impedance.
18
En
SPEAKER L
8Ω ~16Ω
+ –
Twist exposed wire
strands together.
Push tab to the open
position, and insert the
wire. Then, close tab firmly
to secure the wire in place.

Attaching the ferrite core

To help prevent noise, attach the supplied ferrite core to the
connector end of the power cord as shown. Use the supplied
cable tie to prevent the ferrite core from slipping on the
cable.
Europe, except UK
and Eire
To power outlet
AC power cord
UK and Eire
Ferrite core
Cable tie
To AC IN
As close as possible