Connecting The Power Cord - Pioneer PDP-5050HD Mode D'emploi

Preparation

Connecting the power cord

Connect the power cord after all component connections have been completed.
Plasma Display (rear view)
Media Receiver (rear view)
DIGITAL OUT
OPTICAL
I N OUT
VCR CONTROL ANTENNA/ Cable Cable
CONTROL CABLE A IN CARD CARD
IN
ANTENNA B
S400
(TS)
INPUT 2
S-VIDEO INPUT 2 INPUT 1 COMPONENT VIDEO
VIDEO R-AUDIO-L VIDEO R-AUDIO-L Y C B /P B C R /P R
SERVICE ONLY
OUT INPUT 1
MONITOR OUT S-VIDEO VIDEO R-AUDIO-L R-AUDIO-L INPUT 3 Y C B /P B C R /P R
S-VIDEO INPUT 3 INPUT 3
• Use only the supplied power cord.
• Be sure to use the specified power supply voltage;
neglecting this can result in fire or electric shock.
• For the Plasma Display System, a three-core power cord
with a ground terminal is used for efficiency protection.
Always connect the power cord to a three-pronged
outlet and make sure that the cord is properly grounded.
AC INLET AC IN
AC IN
BLACK
INPUT 3
WHITE
HDMI SYSTEM CABLE
Noise filter
Partially eliminates noise
caused by the power source.
Power cord
Noise filter
Partially eliminates noise
caused by the power source.
Power cord
• Always turn off the power of the Plasma Display and Media Receiver
when connecting the power cords.
• Disconnect the power cord from the power outlet when the Plasma
Display System is not going to be used for a long period of time.
06
23
En