Basic Connections; Connecting To An Antenna; Connecting The Power Cord - Pioneer PDP-504HDE Mode D'emploi

Preparation

Basic connections

Connecting to an antenna

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections
that are used for a coaxial cable.
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
Antenna cable-commercially available

Connecting the power cord

Plasma Display (bottom view)
Media Receiver (rear view)
I N OUT
CONTROL
SERVICE ONLY
INPUT 3
SUB WOOFER
OUTPUT COMPONENT VIDEO
Y P B P R
INPUT 1
i / o link.A
SELECT
INPUT MONITOR
2 3 OUTPUT
VIDEO R-AUDIO-L
INPUT 2 INPUT 3 S- VIDEO
• Always turn off the main power of the Plasma Display and Media Receiver when connecting the power cords.
• Disconnect the power cord from the power outlet, Plasma Display and Media Receiver when the system is not
going to be used for a long period of time.
If your outdoor antenna uses a 75-ohm coaxial cable with a standard DIN45325
plug (IEC169-2), plug it into the antenna terminal at the rear of the Media Receiver.
AC INLET
BLACK
WHITE
SYSTEM CABLE
I N OUT CONTROL
SERVICE ONLY
INPUT 3
SUB WOOFER
OUTPUT
COMPONENT VIDEO
Y P P
B R
INPUT 1
i / o link.A
SELECT
INPUT MONITOR
2 3 OUTPUT
VIDEO R-AUDIO-L
INPUT 2 INPUT 3 S- VIDEO
Europe, except U.K.
and Eire
U.K. and Eire
Europe, except U.K.
and Eire
U.K. and Eire
06
AC INLET
BLACK
WHITE
SYSTEM CABLE
21
En