Bort BSS-1600-P Mode D'emploi page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

REPLACEMENT OF REAR FILTER
FOR MOTOR
The rear fi lter for motor is installed behind the air outlet
grid, which can be washed due to the materials used.
When the surface is jammed seriously by dust, the fi lter
should be replaced by a new one or washed by water
to maintain enough suction force. (Figure 6/7)
It is usually necessary to clean and replace the fi lters
for motor only after they have been used for 6 months
to 12 months. Please remember to confi rm that all fi l-
ters have been correctly installed into the machine be-
fore turning on the cleaner to use.
Fault
The cleaner cannot operate.
The suction force is reduced.
There is abnormal sound when the motor
is under operation.
8
Key Points:
The power supply of the cleaner must be cut off before
replacing any fi lter!
FAULTS AND REPAIR
In case of abnormality with this product, please treat
it in the way as stated hereinafter; if the cleaner still
refuses to work normally, please contact the stop from
where this product was bought or with the appointed
service point.
Treatment
1. Check whether the power plug is
inserted securely; pull out the plug and
then reinsert it in the power socket;
2. Check whether the power socket is
electrified;
3. Check whether the switch of the cleaner
is in "ON" position.
1. Check whether the floor brush, the hose
and the spile are jammed, and remove any
blockage immediately;
2. Check whether the air-inlet filter gauze
is dusty; frequently clean rubbish or
replace air-inlet and air-outlet HEPA;
1. Stop the cleaner immediately;
Check whether the floor brush, the hose
and the spile are jammed, and remove any
blockage immediately.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

98295184

Table des Matières