Accessories - Hilti PMC 36 Mode D'emploi

2.5 Information displayed during operation
LED
en
Laser beam

3. Accessories

Tripod
Tripod
Tripod
Tripod
Target plate
Target plate
Laser receiver
Pipe adapter
Wall mount
Drywall adapter
Magnetic bracket
Telescopic brace
Frame clamp
Ceiling clamp
Hilti toolbox
Laser visibility glasses
16
The LED doesn't light. The tool is switched off.
The batteries are exhausted.
The LED doesn't light.
The LED doesn't light. The batteries are inserted incorrectly.
The LED lights con- The laser beam is switched on. The tool is in
stantly. operation.
The LED blinks. The batteries are almost exhausted.
The LED blinks. The temperature of the tool is greater than 50°C
(122°F) or less than -10°C (14°F) (the laser beam
does not light).
The laser beam blinks The batteries are almost exhausted.
twice every 10 seconds.
The laser beam blinks The tool cannot level itself (outside the 3.5°
rapidly. self-leveling range).
The laser beam blinks
Movement of the pendulum is blocked. The foot of
slowly.
the tool is in the closed position.
PA 910
PA 911
PA 921
PA 931/2
PMA 50/51
PRA 50/51
PMA 30
PMA 70
PMA 71
PMA 75
PMA 74
PUA 10
PMA 25
PMA 76
PMC 36
PUA 60 The laser visibility glasses are not
protective glasses and thus do not
protect the eyes from laser beams.
As the laser visibility glasses
restrict color vision, they should
be worn only when working with
this tool and must not be worn
while driving a vehicle on a public
road.