Drilling Countersunk Holes - Olsberg Aracar Compact Instructions

Drilling countersunk holes

Screwing the insulation boards/cladding panels together usually does not require any pre-drilling. The only exception are
the holes on the face side of the 25mm thick panels. These panels have already been pre-drilled in accordance with the
screws to be used.
You only need to drill additional countersunk holes into the 25mm thick cladding panels so as to accommodate the diam-
eter of the corresponding screw heads. To ensure that you drill these countersunk holes at the right position into the corre-
sponding panels, the cladding panels (3-8 from Fig.1 / Fig.2) are shown below in their installation position including the di-
mensioned countersunk holes (grey dots) for door stop left and door stop right. When marking the countersunk holes, pay
attention to the position of the pre-drilled holes (X).
Important: The countersunk holes must be drilled on the smooth surface.
Cladding panels for door stop left
589x635mm
199x732mm
439x635mm
26
all countersunk holes
for chipboard screw Ø6x140 (17)
all countersunk holes
for chipboard screw Ø5x60 (19)
X = pre-drilled
holes
X
X
X
X
all countersunk holes
X
for screw M5x35 (20)
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
589x605mm
144x732mm
439x605mm