Installing Handle; Removing Handle - RIDGID Smart Pulse RV34100 Manuel D'utilisation

SP6906 RIDGID ESF.qxp_SP6636 12/10/14 9:27 AM Page 9
Caddy Assembly (Continued)
4. Slide open end of axle through left
caddy making sure the leg slot lines
up with the cradle hole. Slide all the
way through the right caddy. Light
taps with a mallet may be required to
fully insert axle.
5. Install second wheel onto axle with
smooth portion of wheel facing
outward.
6. Install the second cap nut. Tap gently
until cap nut is firmly seated
7. Using a rubber mallet or hammer,
gently tap the wheel cap onto the
right wheel until the wheel cap is
firmly seated onto the wheel. This is
required on both left and right sides.
8. Insert the caster stem into the socket
of the caster foot as shown. (Front
caster only).
9. Push on the caster until the ball on
the caster stem is inserted all the way
into the socket. You will be able to
hear the ball snap into the socket and
the caster will swivel easily when
positioning is correct.

Installing Handle

Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release
buttons indicates successful engagement
of handle.

Removing Handle

Press and hold release buttons as
shown. While firmly pushing in release
buttons, pull handle upwards to remove
(see illustration).
Left Caddy
Wheel
Cap
Caster
Stem
Caster
Ball
Socket
Handle
Release
Button (2)
Handle
Receptacle (2)
9
Right
Caddy
Mallet