Safety And Visual Warnings; Automatic Standby - Krups XP6025 Mode D'emploi

KR_ESPRESSO_XP6025_NAFTA_8080011600-02 03/07/12 17:49 Page19
IMPORTANT
Once you have let the equivalent of a tank of fresh water circulate through the 2 circuits you can
be sure that there is no anti-scale agent left in the tank nor any residue taste resulting from its use.

5. SAFETY AND VISUAL WARNINGS

The control buttons on the XP6025 include a general safety device that prevents confirmation of any
operation if the correct temperature has not been reached:
- While the TEMPERATURE light (h4) flashes, none of the buttons (except START/STOP) can be used.
Important
The machine is also equipped with visual warnings advising of any misuse of your
machine.
Scenario 1: detection of a fault in the water tank
In ESPRESSO or HOT WATER mode, when the TEMPERATURE light (h4) flashes quickly and the pump
stops, your machine has detected that the water in the tank is at the minimum level and warns you that the
tank is close to empty.
In this case:
1. Turn the rotating control button to the PENDING position (
2. Switch the machine off by turning the START/STOP button (h5) to the (0) setting.
3. Empty the remaining water in the tank and re-fill then re-position correctly (fig.2).
4. Switch the machine on again by turning the START/STOP button (h5) to the (I) setting.
5. Wait until the TEMPERATURE light (h4) stops flashing.
6. Let the water run through the HOT WATER/STEAM spout (fig.3) for approximately 20 seconds
(See section "Hot water function" page 16).
Note:
If the pump has not started completely, the TEMPERATURE light (h4) will flash again (quickly or
normally).
In this case, switch the machine off again. Wait a few seconds then turn it on again and restart. It
may be that you have to repeat these operations 2 or 3 times for the pump to be completely
operational again.
Scenario 2: rotating selector incorrectly positioned
If the TEMPERATURE light (h4) flashes quickly when your turn your machine on, this means that the
rotating control button (d) is not set to PENDING (
In this case, turn the control button to PENDING (

6. AUTOMATIC STANDBY

For safety and energy saving reasons, the XP6025 espresso machine is equipped with automatic standby:
n Your machine will automatically switch to standby when it has not been used for more than 30 minutes.
The TEMPERATURE light (h4) will remain lit but less bright. The main electricity supply to your machine
(thermo block heating included) is interrupted.
n To restart the machine, turn the START/STOP button to 0. Wait a few seconds and switch the machine
back on by turning the START/STOP button to (I).
●
) (if not already at this setting).
●
) and that the thermo block cannot be heated.
●
) (fig.4).
English
19