Frothing Milk; Auto-Cappuccino Set Xs6000; Preparing Hot Water - Krups ESPRESSERIA AUTOMATIC PREMIUM Mode D'emploi

We recommend that you use pasteurised 1 or 2% milk. The milk should be quite cold, ideally bet-
ween 42° F and 50° F (6 and 10° C). After having used the steam or hot water functions, the nozzle
may be hot, and we recommend that you wait for a few moments before handling it.
Fill a frothing pitcher
Check that the steam
one-third and immerse
nozzle is correctly
the nozzle in the milk.
installed.
To remove any remaining milk
from the steam nozzle, place a
cup under the nozzle and press
the " hot water " button .
To interrupt the steam function, press any button.
If the nozzle is blocked, clean it out with the included needle.
The maximum duration for production of steam per cycle is limited to 2 minutes.
The auto-cappuccino accessory makes it easy to prepare a cappuccino or a caffe latte. It is comprised of a special nozzle with
two-positions/markings and a brushed stainless steel milk jug and tubes.
XS 6000
Join the various components to each other.
Choose the cappuccino or caffe latte posi-
tion of the special steam nozzle.
The tube must not be twisted to ensure that the button is held in the correct position.
To prevent the milk drying on and in the auto-cappuccino accessory we strongly recommend that you
immediately:
- put clean water inside the jug and reinstall the different components
- run a "steam" cycle
- clean all parts with a moist cloth.
You can also use our special XS 9000 cleaner for milk systems.
To interrupt the hot water function, press any button. If the nozzle is blocked, clean it out with the needle
included. The maximum amount of hot water per cycle is limited to 10 oz/300 ml.

FROTHING MILK

Press the "steam" button
instructions on the screen.
Run for at least 10
seconds, then again
press the button to
stop steam generation.
AUTO-CAPPUCCINO SET XS 6000 (SOLD SEPARATELY)
Fill in the milk recipient and
place a cup or a glass under
the auto-cappuccino nozzle.

PREPARING HOT WATER

While the screen displays the drink selection menu, press the "hot water" button
A message will ask you to place a cup under the steam nozzle. Again press the
"hot water" button
Once your milk is frothed
and follow the
to your liking...
You can remove the steam nozzle for thorough cleaning. Wash it using a brush
with water and a little non-abrasive dishwashing liquid. Rinse and dry. Before
re-assembly, make certain that the air inlet holes are not clogged by milk residue.
If necessary clean out the holes with the needle included with the machine.
Press the key to launch
and then stop the cycle.
to produce hot water.
9
press the "steam" button
to stop the cycle.Cycle
does not stop immediately.
XS 9000
Place your cup or glass under Cleaner for
the coffee outlet and launch milk systems.
the coffee/espresso cycle.
.