SubGear XP10 Mode D'emploi page 33

Switching the audible attention signals on and off
Switching the water contacts on and off
Resetting the remaining saturation
DESAT
DESAT
With this option you can switch off the audible attention signals only
(the audible alarms remain active). Refer to page 19 to see this distinction.
1. Confirm that you wish to change the setting of the audible attention
signals by pushing
2. Switch between "on" or "off" by pressing
3. Confirm the setting with
On submerging in water the water contacts switch on XP10 automatically.
If you chose the option "Water contacts off", XP10 will turn on with
a delay of up to 1 minute into the dive. This will affect functioning of
the computer.
Make sure that the computer is on before starting the dive.
1. Confirm that you wish to change the setting of the water contacts by
pushing . "On" or "off" starts to flash.
2. Switch between "on" or "off" by pressing
3. Confirm the setting with
Diving after a reset of the remaining saturation may lead you into
potentially hazardous situations which could result in death or serious
injury. After a reset of the remaining saturation do not dive for at
least 48 hours. If you dive after resetting the remaining saturation the
computer will miscalculate your decompression, which may result in
serious injury or death.
Reset the remaining saturation only if you know you will not be diving,
flying or going to higher altitude for the next 48 hours.
Resetting the desaturation should only be done when there is a valid reason,
e.g. loaning the computer to somebody who has not dived in 48 hours or
more. When the computer itself has remaining saturation you must assume
full responsibility for the consequences of resetting the remaining saturation.
1. Confirm that you wish to reset the displayed saturation by pushing
"On" starts to flash.
2. Switch between "on" or "off" by pressing
3. Confirm the setting with
"000" appear.
4. Set the first digit by pushing
Repeat point 4 for the next 2 digits. If you entered the right code the
desaturation will be reset to zero (desat off).
Code: 313
. "On" or "off" starts to flash.
.
! WARNING
.
! WARNING
. If you have selected "off", "Code" and
and . Confirm with
Settings
.
.
.
.
.
33